MCAA Welcomed Four New Student Chapters at MCAA18

April 10, 2018

Four new student chapters received their charters during MCAA18, bringing the total number of student chapters to 57. Jon Finch, Chair of MCAA’s Career Development Committee, was on hand to present the charters to the Robert Morris University Chapter of the MCAA, Indiana State University Student Chapter of the MCAA, MCAA Student Chapter at Auburn University, and CPMCA Student Chapter at the University of Southern California.

Robert Morris Charter MCAA18

The Robert Morris University Chapter of the MCAA charter was accepted by Dr. Tony Kerzmann, Associate Professor at Robert Morris University, and Rege Claus, Executive Director of the MCA of Western Pennsylvania, the chapter’s sponsor.

Indiana State Student Chapter Charter MCAA18

The charter for the Indiana State University Student Chapter of the MCAA was accepted by Student Chapter President Brenden Cox, Faculty Advisor Daniel Bawinkel, and John Rayburn, Executive Vice President of the MCA of Indiana, the chapter’s sponsor.

Auburn University Charter MCAA18

The MCAA Student Chapter at Auburn University charter was accepted by students Eric Brazell, Randall Porterfield, and Chase Lowden, along with Faculty Advisor Keith Rahn and MCA of Georgia representatives Ken Harbour (MCAA Board Member) and Gary Fowler. The MCA of Georgia sponsors the chapter.

CPMCA Student Chapter Charter MCAA18

The charter for the CPMCA Student Chapter at the University of Southern California was accepted by Student Chapter President Steve Yemeli, Vice President Felipe Hernandez, students Alexander Huerta, Alfredo Leal, Julia Lind, Kathy Deng, Nicole Wong, Professor Henry Koffman, and CPMCA representatives Harry Bederian and Chip Martin. CPMCA is the chapter’s sponsor.

Related Articles
Following an energy audit, McKinstry specified Uponor’s flexible Ecoflex preinsulated piping to resolve a remote Minnesota school’s longtime heating problems and save the school thousands in energy costs. Ecoflex proved easy to install, allowing workers to lay hundreds of feet of piping in just one week.…
MCAA’s Virtual Trade Show connects our contractor members with the members of MCAA’s Manufacturer/Supplier Council.…
Prefabrication was just one of the ways that Olson Plumbing and Heating leveraged Viega ProPress to take on a mountain of a project: building a new visitor’s complex at the summit of Pikes Peak that met strict environmental standards … during the COVID-19 pandemic. “We prefabbed all the domestic and hydronic piping, as much as we could, to minimize labor at the top,” said Josh Crippen, superintendent at Olson. “We prefabbed our pump skids, all the water heater and boiler skids, all the waste and vent piping. As much as possible.”…
The Manufacturer/Supplier Training area of MCAA’s website connects our contractor members with training opportunities available from the members of MCAA’s Manufacturer/Supplier Council.…
Load More...