Sponsor Spotlight 22 Welcomes Wayne Garrett from Carrier Corporation

June 11, 2021
In the 22nd episode of MCAA’s Sponsor Spotlight series, Bob Bolton, MCAA’s President-Elect is joined by Wayne Garrett, Managing Director, NA Applied Equipment for Carrier Corporation.

In the 22nd episode of MCAA’s Sponsor Spotlight series, Bob Bolton, MCAA’s President-Elect is joined by Wayne Garrett, Managing Director, NA Applied Equipment for Carrier Corporation. The Sponsor Spotlight Series is a new way for MCAA contractor members to learn more about the Manufacturer/Supplier Council (M/SC) Governing Board members, their products, their relationship with MCAA, and what being a member means to them.

Wayne Garrett comes to Carrier with over 27 years of industry experience in commercial equipment and control sales.  As Managing Director of NA Applied Systems he has P&L responsibility for all commercial equipment business including production factories in both Charlotte, NC. and Monterrey, MX.  In this role he oversees Applied equipment sales through all distribution channels as well as managing Carrier’s national accounts and global export business. Prior to joining Carrier, Wayne held various branch, regional, and corporate leadership roles within the industry.  He has led key marketing initiatives for healthy buildings and indoor air quality (IAQ), central plant optimization, optimized building wide systems’ platforms, and software as a service (SaaS) offerings. Wayne earned his B.S. in Mechanical Engineering from the United States Military Academy, West Point, NY and holds a Master of Science, M.S.M. degree in management from Colorado Technical University. 

Related Articles
Following an energy audit, McKinstry specified Uponor’s flexible Ecoflex preinsulated piping to resolve a remote Minnesota school’s longtime heating problems and save the school thousands in energy costs. Ecoflex proved easy to install, allowing workers to lay hundreds of feet of piping in just one week.…
MCAA’s Virtual Trade Show connects our contractor members with the members of MCAA’s Manufacturer/Supplier Council.…
Prefabrication was just one of the ways that Olson Plumbing and Heating leveraged Viega ProPress to take on a mountain of a project: building a new visitor’s complex at the summit of Pikes Peak that met strict environmental standards … during the COVID-19 pandemic. “We prefabbed all the domestic and hydronic piping, as much as we could, to minimize labor at the top,” said Josh Crippen, superintendent at Olson. “We prefabbed our pump skids, all the water heater and boiler skids, all the waste and vent piping. As much as possible.”…
The Manufacturer/Supplier Training area of MCAA’s website connects our contractor members with training opportunities available from the members of MCAA’s Manufacturer/Supplier Council.…

Did you know MCAA members can enroll with @ClickSafetyOT and receive 10% off OSHA 10 and OSHA 30 training courses?
https://www.mcaa.org/wp-content/uploads/2021/01/ClickSafety-Partner-Discount-Flyer-MCAA-2021.pdf

Subscribe today for SDS Binderworks and make OSHA hazard communication compliance easy with MCAA member discount prices!
https://www.mcaa.org/wp-content/uploads/2021/01/SDS-BinderWorks-MCAA-Hand-Out_2021-compressed-compressed.pdf

.@FARO_TechInc’s FARO® Focus S 350 Laser Scanners “are really allowing us to send one guy in to a project and capture in a few hours what a team of people used to do over the course of a week...,” said Mark Lamberson CPD, of Limbach Holdings Inc.

http://ow.ly/fobd50GjJBT

Load More...