OSHA & CDC Update Guidance on Mitigating and Preventing the Spread of COVID-19 in the Workplace

August 18, 2021

OSHA recently updated their guidelines on mitigating and preventing the spread of COVID-19 in the workplace, which reflects the July 27, 2021 Centers for Disease Control and Prevention (CDC) mask and testing recommendations for fully vaccinated people.

WHAT YOU NEED TO KNOW:

  • OSHA & CDC recommend that fully vaccinated workers in areas of substantial or high community transmission wear masks in order to protect unvaccinated workers.
  • OSHA & CDC recommend that fully vaccinated workers who experience close contact with someone who tests positive for coronavirus, wear a mask for up to 14 days unless they have a negative coronavirus test at least 3-5 days after such contact.

OSHA UPDATE

CDC MASK & TESTING UPDATE

Related Articles
Each week, MCAA will highlight one or more of the educational resources that are free to MCAA members as a benefit of membership. This week, we focus on MCAA’s new safety training video, Master the Mechanics: Hand & Power Tool Safety for the Mechanical Trades. The video provides trainees with information on the most common hand and power tool injuries in the mechanical construction and service trades. It highlights the tools most likely to be involved in an injury incident, and teaches proper use of the tools to help prevent injuries.…
MCAA extends a warm welcome to Raffi Elchemmas, who will be joining the staff starting August 2, 2021. He will be MCAA’s new Executive Director of Safety, Health and Risk Management, learning the ropes before Pete's upcoming retirement. Raffi comes to us from Milwaukee Tool, where he was the National Manager, Health & Safety. He is a board-certified ergonomist with an MBA in Sales Leadership & Health Sector Management from DePaul University. He has been a member of MCAA’s Safety and Health Committee since 2019. MCAA is pleased to welcome Raffi to the staff, and his wife Martha, daughter Nina, and son Vartan to the MCAA staff family.…
STIHL is recalling to repair certain TS 410 and TS 420 cut-off machines manufactured between January 2021 and April 2021. In some of these machines the flywheel can break apart while the engine is running, posing a projectile hazard to the users or bystanders. If you have any of these machines, immediately discontinue use and take them to an authorized STIHL dealer for free repair. …
MCAA’s new safety training video, Master the Mechanics: Hand & Power Tool Safety for the Mechanical Trades, provides trainees with information on the most common hand and power tool injuries in the mechanical construction and service trades. It highlights the tools most likely to be involved in an injury incident, and teaches proper use of the tools to help prevent injuries.…
Load More...